EMAIL:
SALES
GREG
MIKE
DAVID
BRYAN


PHONE:
972-323-0797

FAX:
972-323-0785

   
Index>Home>Sortation>796LSS


796 Line Shaft Driven Converging Spur Module
   

 

Download catalog page in pdf format

SPECIFICATIONS

TREAD ROLLERS: 1.9" dia. x 16 ga. steel, model 196S grooved, 3" centers.

DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.

DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft. NOTE: Spools in spur section only are keyed to provide positive drive (designed not to slip on drive shaft).

COUPLINGS: Couplings located both ends or one end only. Specify where couplings required.

BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. Short side of spur is always 12" overall length.

 

BEARINGS: Precision, lubricated, ball bearing units with composite housings.

FLOOR SUPPORTS: Optional

MOTOR DRIVE: Unit is designed to be driven by 796LS.

ROLLER CHAIN: Spur driven via crossover with No. 40 chain.


NOTE: Specify "right hand" or "left hand". To determine hand of spur, refer to technical section.