TREAD ROLLERS: 1.9" dia. x 16 ga. steel, model 196S grooved.
DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.
DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft.
COUPLINGS: Couplings located both ends (type "A"), one end only (type "B" or "C") or none (type "D"). See 'line shaft coupling chart' and specify.
CENTER DRIVE: Reversible drive; located approximately 18" from end of bed section for 3" and 6" RC; 16-1/2" for 4" RC.
BEARINGS: Precision, lubricated, ball bearing units with composite housings.
SPEED: 60 FPM, constant.
|
BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.
FLOOR SUPPORTS: Optional
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.
CAPACITY: See technical section for load capacity rating.
ELECTRICAL CONTROLS: Optional.
|