TREAD ROLLERS: 2-9/16" dia. x 7 ga. steel, model 297S with sprockets.

CHAIN DRIVE: Roller to roller with No. 60 circular roller chain.

END DRIVE: Reversible drive, either side mounted or underside (specify). Main drive roller is supported by precision, heavy duty, lubricated, ball bearing units.

CHAIN GUARD: Chain drive is enclosed, top and bottom, along entire length of conveyor.

ROLLER CENTERS: 6" RC measured at outside radius of curve.

BED: 4" at 5.4 lbs. and 6" at 8.2 lbs. structural steel channel frame.

BEARINGS: Removable type, heavy duty, ball bearings, zinc plated, grease packed, labyrinth sealed.

BEARINGS: Removable type, heavy duty ball bearings, zinc-plated, grease packed, labyrinth sealed. Roller bearings provide capacity of 540 lbs. per roller.

CHAIN GUARD: The chain drive is completely enclosed along the entire length of the conveyor.

MOTOR DRIVE: 3/4 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

SPEED: 35 FPM, constant.

FLOOR SUPPORTS: SH-4 with underneath mounted drive adjustable 18" to 21" TOR. SH-1 with side mounted drive adjustable 10-1/2" to 12" TOR. Supports should be lagged to floor.

DRIVE LOCATION: Drive located on outside of curve. Specify right hand drive or left hand drive (drive hand determined with reference point located at outside of curve).

ELECTRICAL CONTROLS: Optional.